I get no sound through either bypassed or engaged. This might be an issue with the 1/4” jacks. I used stereo jacks and I’m not sure which lugs to wire to. or just switch to mono jacks.
I’m not getting any power to the gain switch LEDs either. The boost will light up. I’m not sure what to do. I’ve reflowed every solder joint. I rechecked the resister values (my 1M in R22 was only reading out at 10K so I switched it out..... and I know it looks terrible but it has continuity to the back of the board)
Any suggestions? I checked the orientation on the clipping LEDs they seem to be right. The IC seems fine.
I’m not getting any power to the gain switch LEDs either. The boost will light up. I’m not sure what to do. I’ve reflowed every solder joint. I rechecked the resister values (my 1M in R22 was only reading out at 10K so I switched it out..... and I know it looks terrible but it has continuity to the back of the board)
Any suggestions? I checked the orientation on the clipping LEDs they seem to be right. The IC seems fine.