Tayda UV Print Tool Final Update Gloss Testing

[leadfoot]

I know, I was being a jackass!

I'm devastated. Here I was thinking White Test was a modded SD-1 or TS.

 

[jwin615]

Here I was thinking it was the new immigration policy.

 

[giovanni]

Here I was thinking it was the new immigration policy.

New since January 2025 you mean?

 

[leadfoot]

I just received my last test enclosure. For this run, I enabled the gloss layer and used a design from a pedal I built back in 2019. The original artwork was created entirely in Paint.NET for an AionFX Luna.


I exported that original PNG, uploaded it into the tool with gloss selected, generated the PDF, and sent it directly to Tayda.

That looks really good. You consider it good enough to use it?

 

[chongmagic]

That looks really good. You consider it good enough to use it?

At this point, yes. I’ve run multiple physical tests including white and gloss, and the files have passed Tayda’s RIP without rejection. That said, I still recommend reviewing the generated PDF before submission to confirm sizing and layer setup.

 

[Passinwind]

This is fantastic! I passed two bar exams in three days but I couldn’t figure out how to configure Tayda artwork if my life depended on it! I got as far as vectorizing a cool photo of an Echoplex for my EP-3/Aion FX Ares, then hit a wall.

Has anyone tried using this for AmplifyFun? Just curious.

AmplifyFun sends you a pre-production proof for approval, and is much more flexible on artwork submission format to boot. My bet is that if it works at Tayda it’ll work for Spencer.

 

[counterdeliver]

AmplifyFun sends you a pre-production proof for approval, and is much more flexible on artwork submission format to boot. My bet is that if it works at Tayda it’ll work for Spencer.

Thanks for your thoughts!