Tearjerker Wah too much output / pushes amp too hard

[unicursal]

Hey folks!

I just finished building the Tearjerker and absolutely love all the different sounds I'm getting out of it!
However, I'm running into one issue: the output level is a bit too hot and pushes my Deluxe Reverb harder than I'd like.

Is there a way to reduce the overall output gain? Maybe by adding an extra volume/level pot to the circuit?

Ideally, I'd like to bring the output closer to unity gain without changing the overall tone or sweep characteristics of the wah.
Any suggestions on how to achieve this?

Thanks in advance!

 

[OD is Glorious]

Could you post images of the board?

 

[swelchy]

Switch the control knob out to one that only goes to 10 instead of 11