mcluff
Member
Hi all, first thread post!
I installed a Spin FV-1 onto my Leprechaun board, and I think I got the surface mounting done right.
Is there a good way to test it before I populate the rest of the board? I'd hate to think I fried the chip, only to populate the board, and have to start again from scratch.
Thank y'all!
I installed a Spin FV-1 onto my Leprechaun board, and I think I got the surface mounting done right.
Is there a good way to test it before I populate the rest of the board? I'd hate to think I fried the chip, only to populate the board, and have to start again from scratch.
Thank y'all!