zgrav

Are you disconnecting your internal speaker when you plug in to that jack? If you are running 4 ohms on the internal speaker and 4 ohms...

Check the impedance of the speakers. Also, are you using a 1/4" speaker cable or a 1/4" instrument cable?

Hi Robers. Any chance of a drill temp for the 4 tap DC convertir/isolator. And the length of the standoffs requires. Thanks.

@Cybercow must be involved, he often refers to money as "zorkmids", though given his forum-handle I think he should refer to it as...

Do you have electrical tape or something to keep the lower 3 pots from shorting out the pcb on the backside? I’ve had two daisys...

C9 was the problem, rookie mistake of using a 2u2 instead of a 2n2. Swapped it and it is working great. I can not thank you all enough...

At the risk of sounding like a complete suck ass... You are awesome Dave!!! Thank you for taking interest in my original moded circuit...

I still couldn't leave well enough alone. Gator expressed an interest in being able to control the mids. I tried a few different tone...

Thanks, Will. I'm not entirely sure why I waited so long to do it but it's well worth the effort. These days I give such complex builds...

This has been on my build list for a long while (since September last year, to be exact). I took a good couple of days building and then...

Just build seemed quite easy as I just finished a Abductor II delay, which seemed a bit harder to keep an eye on what your putting in.

https://www.pedalpcb.com/product/pcb672/ https://www.pedalpcb.com/product/pcb276/ https://www.pedalpcb.com/product/pcb592/...

Camera angles are important. I had to look a long time to find "that added resistor" . . . .

Here is the message from the Facebook page -- Dear fellow pedal people, If this message gets posted, it means that something went...