Level (Volume) B100K Pot Lug 3 is removed from Twin Face PCB - 220nF Capacitor connects between Lug 3 & OUT Pad of Tone Control PCB.
Tone Control PCB - Connect wire from IN Pad to Twin Face Level Pot Pad 3.
I used a Alpha 12mm because of the 4PDT Toggle switch hence the splayed out PCB Pins.
I built it like this so it would not foul under the Twin Face PCB. Increased R3 & R7 Resistors - 470R to 1K as suggested by Chuck D. Bones to compensate Volume loss.
A Big Thanks to Mr. PedalPCB for the Values & Advice!
Tone Control PCB - Connect wire from IN Pad to Twin Face Level Pot Pad 3.
I used a Alpha 12mm because of the 4PDT Toggle switch hence the splayed out PCB Pins.
I built it like this so it would not foul under the Twin Face PCB. Increased R3 & R7 Resistors - 470R to 1K as suggested by Chuck D. Bones to compensate Volume loss.
A Big Thanks to Mr. PedalPCB for the Values & Advice!
Last edited: