Here's the BOM. There is no Tayda pre-drilled enclosure for this because of the two stomp switches. Pots & jacks look like the standard 6-knob drill pattern, but you're on your own for the stomp switch & LED hole locations until the Build Docs come out. It's a tight fit in a 125B box, so I'd recommend waiting for the Build Docs before you drill anything.
Board is laid out for thru-hole or SMD JFETs. Install one or the other, not both.
I use 6.8uF for C3 to dial back the bass a little when JUICE is dimed, but that's just personal preference.
R101 & R102 are the LED ballast resistors, so adjust their values as req'd.
Have fun!