Latest activity

I haven’t seen a lot of build reports for this little guy, which is a shame! Such a fun and useful little tool to build. Highly...

pm sent

I haven’t seen a lot of build reports for this little guy, which is a shame! Such a fun and useful little tool to build. Highly...

********************** I have been working on a UV Artwork Generator. If you don't have Illustrator or hate dealing with layer...

Verification compares the PCB to it's schematic, as long as each PCB matches it's corresponding schematic (portion) it'll pass...

So then, instead of mixing N4148 with an LED I should just have two LEDs?

This picture how you have it? The build doc says diode OR LEDs looks like you have both in that spot

I haven’t seen a lot of build reports for this little guy, which is a shame! Such a fun and useful little tool to build. Highly...

Verification compares the PCB to it's schematic, as long as each PCB matches it's corresponding schematic (portion) it'll pass...

I did try that and I tried several different bulbs that are good. It won’t clip it won’t light up.

So I tried reversing the light opposite of the N4148 but no light no matter how hard I play no matter how high I turned it up

You could just try swapping the led wires to change the orientation of the led and see if it’s lighting. This shows the case where the...

+1 Mr. Madbean. After I built my Anamorph I gave my AquaDLX to a friend.

Honestly, bit of a pain in the ass to build with a very compressed board layout. Most of the drilling was just done by eyeballing...

I got this protoboard put together and needed something to play with, so I took another run at the Waffle. I tried the purple cat mod...