Robert
Reverse Engineer
I know some of you folks are using KiCad regularly... is there a way to stop these two design-breaking behaviors?
Example 1:
Schematic wires disconnect when rotating a component
Exactly how it sounds... Schematic "wires" don't stay connected while rotating stationary components. Oddly if I rotate while dragging the wires will stay connected.
View attachment Rotate.mp4
Example 2:
Schematic wires become mangled when dragging/dropping components
Schematic wires have a "sticky" behavior, if I drag a component and allow the wires to intersect they become connected if I drop the component
I honestly can't think of a single scenario where I want schematic wires to connect themselves automatically.
View attachment Mangle.mp4
Example 1:
Schematic wires disconnect when rotating a component
Exactly how it sounds... Schematic "wires" don't stay connected while rotating stationary components. Oddly if I rotate while dragging the wires will stay connected.
View attachment Rotate.mp4
Example 2:
Schematic wires become mangled when dragging/dropping components
Schematic wires have a "sticky" behavior, if I drag a component and allow the wires to intersect they become connected if I drop the component
I honestly can't think of a single scenario where I want schematic wires to connect themselves automatically.
View attachment Mangle.mp4