Drilling Questions

[joelorigo]

I have some questions about drilling that I think I already know the answer to but I just want to be sure.

The Cast Iron Overdrive is the standard PedalPCB 5 knob layout?

The pots on the Golden Falk are the standard PedalPCB 4 knob layout (but has the switch where the LED normally is and an added LED hole near the footswitch)?

The Median Compressor is the standard PedalPCB 6 knob layout?

 

[Erik S]

Do you use the paper templates? I think I just printed the ones for Cast Iron and Median.

 

[joelorigo]

Do you use the paper templates? I think I just printed the ones for Cast Iron and Median.

I have several times. But at some point I decided I'd rather pay Tayda to do it than myself.

 

[Erik S]

I have several times. But at some point I decided I'd rather pay Tayda to do it than myself.

Smart!

As far as I know there aren’t any trick layouts that look standard, but aren’t. Can’t say for sure though.

 

[joelorigo]

Just giving this a bump.

Maybe @Robert could weight in if you're out there

 

[Robert]

I have some questions about drilling that I think I already know the answer to but I just want to be sure.

Yep, you are correct.

Just make sure you are using the correct 5-knob template if you're using a drilling service. There are two, one with the LED on the top row, one with the LED on the bottom row.

 

[joelorigo]

Thank you!