SOLVED XC Phase - no phasing

[Jbanks]

Ok, so I finished the XC Phase and put it onto the test board. I get bypass signal, signal when activated, LED on when activated, but no phasing. Any good spots to check? I saw in another forum Pin 7 of IC3 to check for the LFO functionality. Any thing else I should check. Do I need to adjust the trimpot slower? Is it set somewhere in the middle of the sweep?

Pics attached.

Thanks,
James

 

[Jbanks]

I did spot a lead leg stuck to the PCB just below the left switch. I’ll take that off and see if it works. Fingers crossed!

 

[Jbanks]

Removed the lead leg and still no phasing.

 

[Dostradamas]

Trim pot?

 

[Jbanks]

I’ve tried adjusting the trim pot several times and have had no luck finding the sweet spot. Or do you think there’s something wrong with the trim pot itself?

 

[Erik S]

Do I need to adjust the trimpot slower?

I think I remember this one having a remarkably tiny spot where the phasing happened.

I saw in another post that you bought a matched JFET set from small bear. That’s a good start. Have you double checked all your component values?

What’s going on with this joint?

 

[Jbanks]

That totally fixed it! Dialed in the phase mid turn and we’re good to go now! Thanks so much for catching that!

 

[Jbanks]

The finished product. Thanks everyone. This pedal sounds incredible!