Recent content by delackattack

As if this wasn’t a dumb question already, but I’ve added a Simple Clean blend to the Octave pedal so that when the switch is engaged for it, the person can blend it into the mix. I’ve tried send/return In/out with octave effect but once either the Volume on the blend or Octacve is at 0, I get...

WORKS LIKE A CHARM

Im about to wire this up now and i shall share the results soon!

I was experimenting on this for a friend and the goal was to make a 6 band eq that could have this Octave be sent first in the chain via toggle switch. I tried a bunch of different routing and unable to find any diagrams online. Im also not entirely sure i need to be using a dpdt switch to...

So make the cuts THEN flip the image and place the components in their corresponding spots?

Gonna be giving this a go as soon as Im off work! Thank you very much, guys!

Fuck I guess i need to start over and reverse the components???

this could be the case as well, but i was sure i place my components on the side without copper traces

BIG SAME ON THIS ONE

Gotcha, i have done this a couple of times so far and the result has been the same. After hitting it with the probe, i start to loose signal after the first cut on the first row.

This was my first attempt with vero and im not too disappointed in the turnout but my buffer only produces little output when engaged.

It looks correct but I guess Im still a little lost as to checking the volts of the IC

CDIL BC108 from GuitarPCB

I haven’t checked the voltages yest, but I get sound from the legs I need. All but one sound farty/choked. What voltages should I be looking for?

I do not have them socketed but it could be the case that I may need to swap the legs