A Ross with the extra filters and a clean blend sounds sweet. I have a board and daughterboard that I eventually morphed into etching as one board with jumpers that I've been using for years. I made up a schematic in Kicad but when I get to the board, I just stare at the pile of parts. Dunno...
I have built the Paragon and love it. That said, I'm building another. Does anyone have a part number and/or source for trimpots that fit precisely on the pcb?
Tony
Finally got around to checking these voltages. The check revealed high voltage on the collectors and emmiters of Q2 & Q3. Checked the emitter common resistor (R15) and it was completely open. After a swap we are good to go! Thank you again bro!!
Thank you for the kind words!! Much appreciated.
I dont know if it is against any rules, but I could make custom enclosures like this for anyone who needs them. I have full CNC capabilities along with a 2.5 watt laser. It is relatively easy to pull spacing dimensions off of the build documents...
I built one of these... Checked every component as it went in. I have double checked everything and looked for solder bridges. There seems to be no reason for the way that it is operating. There is a barely audible signal with the switch in the up or down positions. It is loud and clear in the...