Recent content by JamieJ

Not as far as I am aware. When I CBA for graphics I either use my label maker or a set of ink stamps. You could also go the letter punch route.

Thank everyone. The biggest use I can think of is recording two cabs wet/dry with two mics per cab so I’m tempted to go for the SSL 12 or MOTU4. I’m using a Mac so logic looks interesting. I would be using it at home 99% of the time but would want to be able to record if I played out anywhere...

Hey! Wanting to do some recording at home but know very little about this world. Any suggestions on the essentials to get started? I want to at least be able to record my wet/dry set up, so I was looking at the Volt 2 or 276/476 from Universal Audio. These come with quite a bit of software...

I think just for that pcb and associated parts with it plus shipping was $150-160 from memory, which I couldn’t justify at the time. I’ve heard great things about that circuit but I love my hydra so I’m not desperate for a new delay.

Is your charge pump the TC1044SCPA?

https://gb.profusion.uk/uk/fxcore-devb

is your jack wiring correct?

That is stunning! Like the Dan Drive style of pedals.

How does it sound @cniers13 ? I was tempted by this but the shipping to the UK put me off.

Spent a couple of days playing around with this layout and I think it’s done. It’s 3 parallel FV-1 reverbs (plus an effects loop) with a LM3900 mixer. The second and third reverbs are wet only and have no dry mix. I absolutely maxed out the pin count in the hobbyist DipTrace so I am going to...

That’s awesome @MichaelW !! That face plate has @szukalski written all over it.

What irked me about mythos was his claims the Golden Fleece and high road fuzzes were designed completely from scratch and it just an electra. I suppose the truth does sell pedals.

Love the glitter! They look awesome

Hi Everyone, Any help here would be appreciated. I have just built a PCB I laid out myself in Diptrace. The effect sounds amazing but the relay bypass is being weird. I am using coda effects switching design and code. When the LED is off, the circuit in in its on state and when the LED is on...

I am planning a utility board build and want to use 6 pcb mounted jacks. Placement is obviously key to avoid mechanical strain on the joints. With the side of a 125B enclosure being angled - where is the best place to place the jacks in relation to the enclosure? See screenshots below. I use...