Recent content by Matopotato

I have no answers to any of your questions, but that is one happy looking potentiometer...

I will try with LT spice to simualye/emulate and see what that gives. The schematic indicate that the input stages of the build are quite similar, so would seem input impedance would be similar regadless of swithing position. Output migt be different though. If the first IC is doing the...

Thanks! How do I check impedance and buffering in this case?

Thanks, Anyone with any thoughts on matching in general: Is light resistance or dark resistance more important to match? Or varies greatly with build/context?

From reading up on a few posts, LDR matching can be very important. (E.g. Phase II as @Chuck D. Bones wrote in #5 here). Is it mostly important to match the light or the dark resistance? Or is that very situation dependent? I am looking at Xenotron build...

I double posted this question on another forum as well. And since then I have come up with a possible solution, so here it is: I think I have figured out as much as that the wires in the wiring schematic from AionFX doc would need to "desolder" the wire+pad labelled: Jack In, Snd, Ret and Jack...

Did you manage to find out the problem an solve it?

Thanks! I'll raise the LEDs a little bit.

I found this thread very useful when building my Tso, so even if I am quite late to the thread I will still share my finding. I had green dimmed and green a bit brighter LEDs to try out. For some reason I wanted the clearer one to the right to be the "best", but the dimmed one gave more...

In the Aion FX Gladiator build the two sides or channels are in fixed order. (TubeScreamer type in to BluesBreaker type) Still they are separate so that there is an input and output for each of the sides. There is also Send and Return but that seems to live its own integrated life. Looking at a...

FWIW II: I managed to get some 63/37 0.5mm and a chisel shaped tip. I think the 0.5 leaded solder does the trick. No real issue with ground plane and it flows through nicely to the other side. With the unleaded it is quite different. I might be able to up my skills and work on with unleaded, at...

This is probably obvious and I might have misundrestood your problem, but I often wire the LEDs so I can put them where I want them. EDIT: I cut the LED legs short but enough to stick out some from the bezel plastic plug-in (?), solder on wire and cover with some heatshrink tube. And then the...

Sure, thanks. I just noticed: Stock, 4xstock, 9xstock were noticeable for bass effect. Probably enough for tolerance differences to not play any major part.

Thanks! I just happened to have 470n, 1.5u and 2.2u in my drawer. Outnof curiosity though, would my initial idea work as well? And a 1M would be enough for pop reduction say between 1 and 2 pins on dpdt? I understand that other caps and spdt is preferred, but I just wanted to learn if my idea...

Thanks for the pop tip. I guess on the dpdt version, 1 M will be enough?