Recent content by OD is Glorious

I may have assembled a bunch of PCBs but I think I am right there with you both. I love that we are on this journey.

I like that you spend time on proper graphics.

Good idea. I have to say, I was a bit down on the circuit until I paired it with my Super Reverb.

For this build the BOM calls for MA856 diodes but I was sick of looking for them and the MA858 replacements so I used IS1588s. I also did not have the JRC4580D op-amp so I used an LM833. The circuit gets crunchy on the OD and boost settings and it gets creamy mid hump distortion on the...

It is cool. ❄️

Thanks for the message. I will have to do some reading - I m sure my luck will eventually run out with the JFETs since I am using them right out of the bin.

I find that the trimmers require attention in octave-circuits.

Dang, I just love that there are always circuits to get wowed by. As always, great execution!

Not yet! Usually when something sounds great I endeavor to leave it as it is.

I agree that this is one of the best bang-for-the-buck PPCB boards. Glad you like it.

Thanks much. Yes, my build reports have a few thumbs down. But this one is a top tier circuit.

I love this circuit. A glorious overdrive circuit that can dial up crunchy and transparent overdrive or it can get you to Plexi-territory. I never touched the three trimmers because it sounds great with lots of tones and plenty of headroom. I can roll off the gain and make this thing into a...

Thanks for saving me the trouble. I will refer to that write up before I begin.

Yes, I need the box to be light and usually smooth. Just for labeling purposes. So that one looked like it fit the bill for me.

Thanks! No worries. I probably need to branch out because I’ve been building too. Many PPCB boards. Also, right now I’m looking at a ppcb soul VENDOR project and like what transistor is that? Now I gotta go search the world for a transistor.