Search results

What about lead free solder and lead free HASL pads? Heretic? I used around 300gr lead free solder during the past years and it’s fine :) Lead free pads are more expensive so I get them with lead in the orders of JLCPCB

Yes, yes that was the problem... Thanks for pointing it out!

Solder flux can cause contact dermatitis that’s why people should wash their hands before using the restroom. The pensi touching was not meant as a joke. But as always it depends on the ingredients.

Everything that is not conductive will do. Clearcoating it would be best if you want to keep the look. Or do it like it should be done with every other electrical appliance and turn the power off before handling power cables ;-)

The Radium Girls are calling from a hundred years ago. Someone once told me that soldering is completely safe if I follow these rules: don’t put your snout above the soldering iron and wash your hands before touching your pensi or licking your fingers. These rules can somehow be followed by...

Nice builds, I have my Omnilooper on the bench or in the corner of the bench still waiting. Regarding the jack just spray paint the hole. Better than tape.

Hello fellow lovers of the seed, this is not a question but an recommendation: for the love of the almighty get an ST-Link adaptor. I forgot about how dumb it is to always push buttons when using the standard USB jack for the programming. Then I remembered that I had this STLINK MINIE3 which...

Maybe this can help with the latency https://forum.electro-smith.com/t/latency-of-pitch-shifter-on-petal/1065/3

The Blackstar HT5 MKII should be cheap by now as the MKIII was released. I owned it and the clean channel sounded amazing but I disliked the dirt so I sold it. Should habe kept it…

Scroll down to assets https://github.com/HolyCityAudio/SpinCAD-Designer/releases If you clone it the releases are not cloned I guess.

Ouuuu I also have to build that thing… Maybe I have the same issue then.

Your welcome. Finally I could help somone :-) I asked him and he told me that he though tit would fit. I wanted to play around with different led but have placed an order just today (another shop).

If manual is only noticable at the higher settings then try to put a small sheet of paper between the led and the resistor. Maybe the LED is too bright. I did it like this for LED4. Try it, doesn’t cost you anything...

Dang it you are right, I forgot it because I was stupid enough to just copy it. Will try!

Thank you for the explanation. I don't want to hijack this thread but are there other options to eliminate squeeling in this circuit? https://moodysounds.com/wp-content/uploads/2020/04/hjart-muller-kit-sve2c.pdf

and/or check the opamp. I had a nasty whine in a ts style od even in bypass and a switch from tl072ip to ne5523 solved the issue.

What instrument do you use? My passive bass struggles to get the crackle. I need a booster before it. For guitar no Problem.

Buy one of these then the 40 bucks are slightly justified :) https://s3.eu-central-1.amazonaws.com/elektormagazine/shopify/17123%20-%20741_datasheet_revB.pdf https://www.elektor.de/products/the-xl741-discrete-op-amp-kit

@Fingolfen that is a perfect ice breaker if there are some gear neards asking stuff about your pedal. "How is this not a dino?" "My friend, let's start 300 milion years ago".

I forgot to add the link… https://github.com/openscopeproject/InteractiveHtmlBom/wiki/Installation Regarding the grid I had many including 2,54mm right after the installation. Never had to add a new one. Beware of a grid change between projects, wenn you copy parts of a schematic to a new one...