Search results

So eq's, compressors, and reverbs together make for some incredible clean sounds. I originally built a pedal called the Soundboard that combines the 6 band eq, delegate compressor, amp cab simulator, sproing reverb and dry blend that is a delight to play. So much so @jjimi84 still has not given...

I want to hook up a sequencer to a the time control on a delay via the cv output. I know it should be possible with a vactrol. I hate to ask but would anybody be able to illustrate the hookups on a picture/ diagram of a vactrol? I would greatly appreciate it!

After. Very much after.

We need more bit fuzzes in your shop!

I am currently working through one of the most frustrating streaks of having consecutive issues with my builds. It's all I have not to give up. This guy tried my patience. With the amount of boards I have fried I feel like I am opening my wallet only to have a gorilla come up and punch me in...

Here she is....

I did. Continuity was there but the signal would shunt when I plugged in a 9V. I found out it was a faulty lug from me heating it too long. Got the whole shebang working again but it will definitely need replaced.

I have to disassemble and reassemble. It is possible the foot switches went bad due to my soldering.

I put together a few pcbs to make a really raucous fuzz. It all went south after putting it into the enclosure. I know something is shorting out but my question has to do with the bypass; I am having the opposite problem that newbies have! Bypass works until I plug it into the 9V plug. The...

A100K pot is properly connected. All unsoldered lugs have continuity to the solder pads. Copy that. Will continue after I solder on two new B100K pots that just broke from me bending them back and forth...damn metal fatigue.

Yes, I do. Are you referring to pin 2 of IC1 or pin 2 of R2?

R1 is the correct value. Replaced it with another 1M resistor that I measured to verify it read the value. Still comes up with the same reading of 0.001M at R1. I reflowed solder at all the joints and still no signal at joint 2 of R2.

R2 is correct but R1 is reading 0.001 on my meter so this could be a bad resistor. I'll replace it and see what happens.

I built the magnetron and there is no audio at all upon firing it up. The rate led works in conjunction with the controls. All the voltages in the ic chips were good. I swapped chips to check for bad ones, no dice. So I decided to use an audio probe. Pin 1 of R2 had a modulated signal but pin...

The Buff n Blend is what I use to put all my circuits in parallel. This was a my first parallel build that I had sitting around forever that I never bothered to put a wrapper on. The board has a pinout for a 100k pot for clean blend. Instead I used a 47k resistor to keep it at the midpoint and...

Double Guitar PCB D'lays that is. Don't persecute me but I took the photo before realizing I forgot to hook the wires to the power jack. Also a quick video of the pedal in action. Both pedals are in parallel so varying the rates produces an excellent texture effect like the Hydra. The benefit...

Thank you for your reply! The volume is low throughout. I do have a sole 12k resistor there, I ran out of 15k's.I played around with the values there 10k to 18k and did not produce any discernible effect different from how it currently functions.

I have a dual hydra build going. One works just fine (I damaged a trace on the feedback pad of lug 2 and had to jumper it to the fv1 chip). The other one is throwing me for a loop. It is very low volume. Increasing the value of the volume pot from b100k to b500k does increase the level to unity...

Definitely building this!