Search results

https://drive.google.com/file/d/1oTUihn1jvU5vcJEUFbvOtuydGQMoyfZl/view?usp=drivesdk

Hello, A friend of mine recently acquired a little electro harmonix Mel 9 pedal. As im sure you can assume. He used the wrong voltage and popped D2 on the board. I need help identifying what the diode is. Does anyone have experience with these?? Also if this isn't allowed I apologize and will...

I switched out the 3.3m for the correct 10M resistor and that seems to have done the trick.

Thanks for getting back to me so quickly! This is probably my 30th build or so. So as you can imagine I'm frustrated with myself. I attached a link showing the in and out jacks. I'll go back through and look for solder bridges. Thats the only think I can even think of. It's bizarre that the...

https://drive.google.com/file/d/1huv0laOr5Hpf3BCSV9g2I7-T-wxlsnWk/view?usp=drivesdk

https://drive.google.com/file/d/1i03uqRmlHZMYqFFQfK98AQLrk996wDiC/view?usp=drivesdk

Also I have been trying to upload pictures but no matter what I do it says they are too large for the server.

Hello, I just finished up a build on a General Tso tonight and its not working properly. The footswitch wire is bizarre to me and for some reason I see to be getting continuity from ground to the Tip on the input jack? As far as I can tell I have everything wired correctly. I did sub a 3.3M for...

I am asking if there is a way to wore this with out the breakout board. Sorry for the confusion!

Its the second footswitch that controls selection of Speed 1 or speed 2

Does anyone know how to wire the speed 3pdt switch without the breakout board? I believe I fried my footswitch and the board all in one stupid sitting.... Thanks in advance!

It seems to work find now except if you turn either of the speed pots too far the bulb kind of flashes then stays solidly lit. It also seems to flash really bright when pressing the footswitch that controls the speed. Any ideas? Maybe a bad L78L12? Of course this is the one build I didnt use...

My only other thing is maybe a bad Yep! They work as they are intended. I was using my DMM to check for shorts and what not and noticed if I touch the center lugs of the speed footswitch it causes the solid lit lamp to start flashing at the full speed per the potentiometers setting.

Hello, I am just t finishing up my second electrovibe build and I'm having a few issues. When I plug in the power the lamp lights up like my first build and starts flashing. It then stops flashing, then randomly sometimes it will be working fine and if you increase the speed potentiometers at...

Thanks, I think that is the route I'm going to go. Thank you all for the help/advice

So if idid want to go the intelligent relay route, is that one of the relay pcbs on the website?

Thanks for the quick reply! Thats what im trying to achieve, the magic switch works only when holding the switch. I've never used a momentary switch before, is there a specific way it needs wired and would it need to be "normally open" or "normally closed? Thanks again!

Hello, I apologize of this has been covered already, but can you use a momentary switch for the magic footswitch? If so does it need a relay, I noticed an older post that used relays for the Leprechaun build. Thanks in advance!

Do you have the Tayda Drill Info for the Leprechaun? Thanks in advance!

Thank you! I appreciate it.