Search results

Last I checked they did not post anything in years

Look at a few build reports here, you will understand how it all goes together

Your document has only one layer, named "Layer 1". Tayda wants you to have your layers named, from bottom to top : WHITE, COLOR and GLOSS-V or GLOSS-M Also, is there any white left in your design ? There should be no white in the color layer. I've done at least one project without the...

I just googled for medusa images in black and white and picked a few that I liked and tried them to make a final choice. Then used inkscape to auto trace it and reworked everything bit by bit to have the image cut out of a black background.

Thank you, gloss over black and luckily I had no QC error on that one.

Just finished this one last night. Everything worked as it should first try. That is really satisfying. It's my second chorus build after the AionFX take on the Small Clone and I took extra time on both those builds to pick the closest values I could find for each component. It really paid off...

I get it's not the look you wanted but I think it's kinda cool, like an aged finish.

Thank you ! Someday I might try with a 125C OT, but for now I just don't have enough time.

I had a bad 12AX7. Ordered 2 of those and tried it with those. It’s now alive but still too quiet for my taste. I want to test it on another speaker. But my heater voltage needs to be checked first. That's the only voltage that looked out of spec.

680 and 68 gives 748 if you want real close...

You should start your own troubleshooting thread. Provide clear pictures of your board and all wiring connections.

Aion L4 requires an LM13700, maybe the L5 also ?

I finished this one a couple weeks ago, I'm not quite happy with it, it's rough. It cuts all the signal on the first third of the pot, then is really hard to dial in. When I ordered the transistors, one of them was out of stock but a "direct replacement" was proposed. I used it and I'm not so...

If you have a cm/in ruler, check it out. On the Theseus, the inch scale is perfect, but the cm one is not right...

I think you start from 1st pic. But yellow goes to the order switch (orange in second pic) Then the two other sets of the order switch would go directly to boards in amd out pads. Someone can validate this?

I think a simple SPST can do the trick... cut the power rail right at the source, before powering the boards and led. Like I did here : Ok ... hard to see. But here I have two boards and a led (plus footswitches and order switch). If on battery, the input cable must be plugged in for the...

Is your power + soldered to both the + and ground pad ?

Where did you sourced the ICs ? Mine did not work at first cause of a fake BBD.

Well, they work but just not the way I thought they would. I was just surprised by the discovery. When I used them in builds, I would just assume I put them backward in the first place, and technically, it's true. Now I know better.

Going by the leads would be fine... but what with the plates ? Here are 2 red on the left and a green on the right. All have flat side on the left side... so they should all have the flat for the cathode, but the red ones really are reversed. I might just have to test them again.