Search results

i like your suggestion, it's a good solution to avoid the diagonal, but unfortunately the 22K would then be immediately adjacent to/'rubbing' against' the 47K - which would be a technical foul - cos these 1/2W resistors kinda need to have an empty row/column between each one for enough...

everywhere? what about https://www.sabrotone.com/noisy-cricket/ https://tagboardeffects.blogspot.com/2012/04/noisy-cricket-mkii.html

nuisance socket strikes again :p

update: there was x1 error in the previous layout. (found out the hard way on this build attempt) easy fix. diagonal jumper isn't ideal, but it works so i'm happy. now verified 🥳 confirmed 34 wide does fit well in a 1590BB/BB2, but it is tight. (evidence)

https://www.taydaelectronics.com/8-pin-dip-ic-socket-machine-tooled.html

mine didn’t. with all knobs cranked, no oscillation / no squeal.

yep, aionfx docs are great for those little bits of extra info. as discussed on your zonk thread, zonk = MkI tonebender. (mkI, mkII, mkIII are all quite different from each other, with mkI being the worst in every way)

I'm assuming you're pondering the right transistor for Q3? the front end is essentially a MkIII tone bender. here's some good advice on the MkIII: (aionfx) (fuzzdog) note: the bias control pot will affect Q3 idle bias voltage, so i guess it's probably best to have it set in the centre when...

ayy thanks 🤙 it's bit of a slog to finish, but will be well worth it in the end!

post up some voltage measurements at each transistor pin if you can. would be interesting and possibly valuable to confirm what the idle bias voltages are. if the idle bias isn't quite right at certain spots, it will not operate correctly. the zonk is basically a Mk1 tone bender. they are an...

the Mofeta board is ripe for Plexi mods. like this: but also, @Guardians of the analog is right. build an SD-1. boost your amp and let it sizzle.

that's a good point, this layout has 35 rows 🥵 IIRC most vero seems to max out at either 34 or 35 rows, so im guessing it's been designed for the absolute limit.

it’s ready for you 🫶🏻

crikey etching one of these would’ve been a heck of a task, nice one 🫡 cheers! 31x 100nF caps, x9 offboard pots; definitely a good time haha thanks! took me ages to figure out that knob layout, pretty stoked on it though.

thanks 🤟🏻 it’s solid core wire from tayda https://www.taydaelectronics.com/awg-22-red-hook-up-wire-1ft-30cm-solid.html

i’m a fan of PT2399 delays. they’re a great definition of ‘cheap and cheerful’. and despite the idle ‘hash noise’ they tend to have, i don’t really notice it enough for it to matter in a context where guitar amp + speaker cabinet is involved. (in a DAW, i guess they can become undesirable) i...

DC

after breadboarding an MT-2 and doing some deep dives i become aware that the pedalpcb shop has a board for a pedal that Randall released a while ago, called the RRED pedal. it’s pretty much a bang on clone of the Randall RG100 red channel, except with the ‘saturation’ switch mode hardwired on...

👀 sick build man 🤟🏻 might have to breadboard this one soon.