Search results

you sure? That guy doesn't even show build reports :ROFLMAO:

"It do be like that sometimes" My guess is Bad IC chip, stray strand if wire touching something it shouldn't, internal trace with a dead end.... Your soldering looks pretty decent.. especially since you did a reflow and theres more solder than usual at a joint... I've seen noobs in here with...

Yeah... I'm impressed you don't have a computer.. I'm currently scanning our man cave downstairs where myself and my 3 teens all have our own rediculously overbuilt computers with watercooling. It would have cheaper for me to just give them calculators...

I bought a set of alphabet rubber stamps that are 1/4" letters and use testors enamel model paints for labeling occasionally... I also bought a set of metal stamping dies from harbor freight that has letters and numbers for stampings... on those I smear in enamel into the stamping and wipe real...

They are for wiring to your input and output 1/4" jacks... specifically for the sleeve

When I get home later I'll probe my personal protoboard... From what I remember my voltages are a lot closer to values

Wondering if you installed the correct parts for your voltage regulators... Snap some pics that are clear so we can see your resistor bands and all the things..

I still do it every once in a while 🤣

Nice job!... Here's a little tip for that middle potentiometer so do don't blemish your caps... We see your mistakes.. lol make sure you clip the leads fairly flush where the pot goes... clean the back of your pcb with 99% iso.... then place that middle pot in the pcb and solder it in from the...

probably pictures of my electrovibe builds in the build reports with that same led lens

It's probably the same hole size for the electrovibe faceplate as well..... I use basically the same as jcpst suggested but the 5mm version... you have to open up the faceplate hole slightly for the 5mm version.... i just do it with a drill bit by hand with my oversized/undersized drill bit set..

watered down iso doesn't do much good... ya gotta have the 99%

Start a new thread in the troubleshooting section.... First thing you need to do is get some 99% isopropyl and clean your board... All that flux is pretty bad. Your soldering definitely needs some more dialing in and likely the culprit.. but also your transistor selection/ pinout could also be...

Got'eeeeem

I recently lined up over a dozen dirt box builds and played through them in succession.. it's pretty ridiculous how close they all sounded once your in medium gain territory.

I'm gonna have to build one out this weekend because I've built around five of them and so far I was in love with all of them... such a simple little dirt box and they sounded good.... I never noticed the fizzies or bloom at the end... But then again I was probably bust banging away playing...

Newbs.... I like to have mine super bright so they can be seen from space.

Next time try not to make the build look so clean.. it sounds better with rats nest wiring..

yeah as others have said... you have to have the drill service for each enclosure added to your cart with your order... When you check out that order it will then prompt them to add drill service to your drill service page.... There's a couple different pedals I have them drill.. one being the...