Search results

Are the germanium diodes the correct way round? They look wrong compared to mine.

Any diodes you reccomend? Also is the anode/cathode the right way round in the clipping section?

Hmm. I have 1n60p’s. Would you reccomend anything else then?

Was a bad tranny, but noisy. Im still gonna investigate ;)

Thats brought signal through, but i find the gain gets pretty low with the octave cranked and i can barely hear an octave. Even on neck pup with tone rolled off.

I have exactly the same problem.

You are beautiful thank you!!

Aaa you flippin legend!! What resistors by chance would they be?

Hello! Wonderful pcb and effect. Is it possible to mod this for dual footswitches 1 for the main on/off And 1 for a mod for just the fuzz, no oscollation or octave, just pure fuzz, And also when is thr schematic going to be released for this?

But the control layout is technically reversed..?

Also, the drive section, is it (looking at the finished box top down) Vol gain Blend boost Tone clip

So.. looking at the order on the pedal it looks like the boost is in front whereas the actual pedal the boost is after the drive?. I may mod for an order switch but im just writing to clarify..

Bit too busy for order wiring. Heres with led 4pdt

C5 increased bass, from 470nf to 1uf. Maybe nice to have as a bass switch. Ic, r12, gain pot didnt do much tbh. Removing r9 rendered the gain pot useless but increased the gain by a small amount. I didnt want to removed the clipping diodes as i feel it may reduce the touch sensitivity to the...

The lm833 gave a hair. I dont know about the gain pot. What if i reduced r12 by half and the cap doubled? Im assuming the greer is a ts derivitive.

So with it set above unity, low cut 0, presence and bright switches at its highest setting would you get feedback with high gain? Also. There is a shitload of gain. Like a metric ass tonne.

Anychance of increasing the gain? Any mods to do?

Id say congrats kelmark. But dont helpeth moi.

s Here is picture of board. I recieved More 2134 from mouser but still same issues.

Can i change the 100k gain pot to a 250k pot to make a high gain version?