Search results

I would try reflowing the solder joints. These look like they could have bad connections but I would probably flow all of them.

That came out nice. I also felt this one was pretty hard. I think I like the switches they sent you more. I haven’t been keeping up here lately. I hope everyone is doing well. I have been taking a break from building while we move and I setup my new office/shop. I’m hoping to get back to...

What an awesome build. Good job!

You can print lots of pedal parts and templates that you might find helpful. I have been thinking of doing faceplates recently. Nearly every build I do has some 3d printing involved.

You can get a passably low level of hum with lower gain and volume. I had been pretty happy with even the unshielded pedals until I got into playing some metal stuff recently. You can get a passably quiet enclosure with copper tape shielding and shielded input and output wires. The reason I...

Sweet builds. I too have a tendency to be pretty focused on things that interest me. This has held my interest longer than most things and is pretty affordable.

This is very impressive. Awesome job!

I think diffused or not only matters if you are feeding the light into an LDR. These are clipping diodes so the color matters as they have different forward voltages, it will make the clipping asymmetrical, but diffused or clear doesn’t.

I have some guitars with splits and the way I like to use them is almost like a boost. When I’m in humbucker it’s usually either dirty or distorted and when I go to single it cleans right up. I don’t think I would bother with the 250K single coil mode. I think if anything I might play with...

Hey thank you! I got them here but it looks like they are out of stock. https://www.amazon.com/gp/aw/d/B01MUF104V?psc=1&ref=ppx_pop_mob_b_asin_title I have quite a few left tho.

Awesome build! I think this was one of the more challenging builds I had done. I agree that the triggering can be a little difficult. I think the labels for sensitivity and intensity are swapped on your build. To make it trigger more easily the far left control gets turned clockwise. You...

That’s a cool pedal. It hadn’t been on my radar but it sounds like something I would enjoy. I noticed many of the Aion builds take the narrow capacitors like that, on a few I have installed caps on the back to make it all fit.

I think some of the joints need to be reflowed. It’s looks like this one may not be making contact. I don’t think it’s D1-4.

Your awesome new builds will be missed. Hopefully you come back from your break refreshed and with new ideas.

Can I use a 4PDT switch for the gain control and the following diagram to add a volume control for each of the gain channels on the stockade? My schematic isn’t the best so I will describe it also. The idea is basically to switch to either volume pot like how you would with a 3PDT bypass. My...

I have dabbled with EasyEDA a bit and found it to be fairly intuitive to use. Your work is inspiring me to want to make some actual boards with it. I have only designed and made a 3PDT bypass so far. For your boards with the SMD components do you have them install them for you?

From the schematic C15 should be a 1n5(152) but those are pretty close so I’m guessing that’s not it. Everything else looked right. Did you ever go back and make sure the rotary was in the right spot? I think it should go in the square with the 2 next to it but @Robert would know for sure.

You have prolific with your own boards lately. I’m sure you have probably answered this before but which program are you using and how long do these take you to design?

My guess is the trimmer or socket.

Did you go back and adjust the bias? I’m not sure where that is located in the circuit but if it’s for the boost it could be the issue. Some circuits wont make a sound if the bias isn’t right.