Search results

I'm just built a Bluesbreaker and it's not working. Both the volume and drive pots are acting as passive volume controls, so there isn't any volume boost at all with the volume knob all the way up, it's the same volume as when it was being bypassed. I know Bluesbreakers don't give much of a...

I built the Windmill overdrive (Catalinbread WIIO) and I'd like to adjust the clipping... it clips a bit too hard for my taste. Which resistors should I adjust to make the clipping a bit softer? Any help would be appreciated. Thanks!

Hey guys, I'm looking to build a signal switcher... one signal in, three signals out via a single three-way toggle. How might I go about that? Thanks!

So I built a Tone Bender with some MP40 transistors and it sounds a little weak and not as sustainy as I'd hoped (predictable). Any tips on how to get more gain out of it without changing the transistors?

Built the windmill a few months back, sounds good but it's a little dark. Here's what I want to do: 1. Add more treble 2. Cut more bass Basically, I want to expand the range of what the pots do by swapping capacitors rather than the pots themselves. Any ideas? Thanks!

.

Any suggestions on how to get more volume out of a Bluesbreaker?

Are the switches for the contour and presence mislabeled on the circuit board? My presence switch doesn't seem to do anything and the contour switch just sounds weird... Any help from those who are more familiar with how the circuit boards are laid out would be appreciated!

We need more Vox pedals!

I'm building a Cross Contaminator and I'm wonder what I could substitute for the 2N1711 germaniums because they're quite expensive. Any thoughts? Thanks!

Hey guys, I'm looking to add a switch for some different bass response values to my ODR1 clone. Which cap(s) control the bass in the Nobleman? Thanks!

I think it would be really cool to put a VU meter in a pedal. Does anyone know how I might go about wiring one up?

Hey guys, I just wired up a the Tone Vendor MKI and it's not working. I've built many pedals before so I know the basic checklist to go through... check for shorts, re-flow solder joints, check the switch, etc. This one just isn't working. I'm thinking maybe it's the transistors? Also, I subbed...

I built the Pardise overdrive last week and it sounds awesome, I just want to cut the bass a little bit. How can I figure out which cap(s) to change?

Hey guys, I want to build a Tone Bender clone, but I can't seem to find any OC75 or 2G381 transistors. Is there anywhere I can buy them?

Just finished my Van Pelt, hand-painted by my sister. This is my second board from PedalPCB, and it's awesome!!