Search results

yeah im working on sorting nets / wires that are routed a bit lazy. ill update what i find. thanks for your input

Hello. I built a vintage univibe clone, SMD version, and it works flawlessly in regards to the vibe function, yet, there is some separate noise sneaking through. The noise is a swish swish swish with the bulb flash that is separate from the vibe effect sound. All other aspects of the pedal...

how to add a simple buffer to pedal? jacks? mainly from the buffer, im wanting to eliminate switch popping on and off.

yeah i tried the C pot just before i saw your message. Now i have full dial sweep effect. perfect! Stock should have been A500K, yet a lot of pedals have terrible tapers on their released pedals, not well thought out at all. I went from A500K to C50K and its simply spectacular now. thanks for...

I have a boost pedal, its going great, but the boost dial / pot, almost all the effewct comes on in the last 5 %, from about 7-10 is where everything happens, nothing before that. Ive tried A100K and A500K, and seems to be about the same. Would it be more than just the pot? Suggestions please.

my circuit is a fet boost running a buck voltage boost circuit at 132 volts, with a 3 band EQ and boost knob only at present.

can you draw picture, not sure about where to put the caps? lugs?

good plan

yeah wiper is output. no low end lose, only high end treble, more treble lose the more you lower the dial

the pedals a high volage fet boost. unity with amp with this pedal is when boost is at zero. a master volume would allow to lower overall output and use the boost as a drive. it goes very loud as you turn up boost. needing an output master volume

Hello everyone. I have a general boost pedal. I want to add a volume / master volume control on the output jack, yet just adding A100K pot seems to take away some of the high frequencies, i.e. you loose treble (or brightness) while turning down the volume pot. I want to retain the treble /...

oh all good. any adjustment with throb on vibes is a good mod. My vibe has a really nice balance of preamp and throb, but i feel a little bit more depth would be nice. its a bit of perfection / obsession going on, but results have been good so far. ill post a video and audio result over next...

so this is not a type of bias mod for bulb, completely different area eh. As i have a bias mod and it made a huge difference at getting a better throb. Yet here, my only goal is to have the entire vibe circuit and effect come forward more wet and sort of over shadow the output, slightly. just...

thaNKS A lot. ill give it a go.

im not sure how where the three pins of the trimmer pot go after i change the resisters

you mean change both 100k resisters to 91K, and add a 20K trimmer pot. how will that increase throb? just trying to get my head around that part. sort of seeing it

change those resisters to what rating you think?

be a good place to start. what do you suggest in my original schematic i sent , where to put changes?

or this area of a vibe circuit? the output mix mod

this sort of gives an idea that it can be separated?