1p8t mini rotary

[bschobs]

Found and ordered a couple of these, is it the right one for the arachnid?

Mini 8-Way Rotary Selector Switch - SP8T

When you need a lot of options, you need a Mini 8-Way Rotary Selector Switch. This is basically a single-pole to 8-throw switch. As you rotate the knob around, the middle pin will make ...

www.adafruit.com

Thanks!

 

[Nostradoomus]

Yes

 

[bschobs]

Good deal! Thanks!

 

[bschobs]

Now if I can just find that crystal with small bear bearing closed... ?

 

[Robert]

Now if I can just find that crystal with small bear bearing closed... ?

32.768 kHz Crystal Cylender 3 x 8 mm

KDS - Get It Fast - Same Day Shipping

www.taydaelectronics.com

Here's the 3.3V regulator too:

L78L33ACZ 78L33 + 3.3V Voltage Regulator IC

SGS THOMSON - Get It Fast - Same Day Shipping

www.taydaelectronics.com

 

[bschobs]

Thanks! Do you think the quality on the Tayda crystal is ok?

 

[phi1]

It’s worked fine for me a few times.

 

[Ratimus]

Heads up - Adafruit is now sold out, but these folks have them: https://www.robotshop.com/en/mini-8-way-rotary-selector-switch-sp8t.html

 

[steelplayer]

Thanks for the heads-up on robotshop.com!

Heads-up: Was able to get a couple, but they're out of stock as well -- resupply expected June 1.

 

[Robert]

The 1P8T and 2P4T rotary switches arrived today, just have to get them counted in the morning then they'll be available.

 

[Gordo]

THIS is great news. Will be watching the store like a hawk and also gives me a cheezy excuse to pick up a few new projects...

 

[Robert]

The 1P8T, 2P4T, and 1/4" jacks are available now.

 

[Kroars]

Heads up - Adafruit is now sold out, but these folks have them: https://www.robotshop.com/en/mini-8-way-rotary-selector-switch-sp8t.html

Thank you so very much for the heads up!!! Just ordered a handful from RS!!!

 

[mstrat]

Thanks! Do you think the quality on the Tayda crystal is ok?

I've used it many times without a problem.

 

[Makemoremusic]

Random aside, does anybody know off hand what size knobs would fit on this? There’s no description on the small bear page.

 

[Paradox916]

Thanks! Do you think the quality on the Tayda crystal is ok?

I believe you could also use a clock module In place of the crystal it’s appropriate for your application, if I’m not mistaken.

 

[phi1]

Random aside, does anybody know off hand what size knobs would fit on this? There’s no description on the small bear page.

Regular set screw 6.35mm knobs fit it, that’s what I always use. Not sure if any knurled shaft pots press onto it.

 

[Dan M]

Mouser stocks them too (I don’t remember that being true last year):

https://www.mouser.com/ProductDetail/Adafruit/2925?qs=%2Fha2pyFaduh07FuJIQU8QfmJrDjjs0%252BN%252BKzEZsSr3VUAtdnxSWUurw%3D%3D