2 More compressor builds - General Tso's and Convex

[Feral Feline]

I solder all of my pots and switches outside of the box, and most wiring once it's in the box.

Sure, but you just verify the circuits work, and then throw all those builds in the same one big box.

Some of us have to drill holes in smaller boxes, holes that have to line up with the populated PCBs, and use the pedals after they're built.

Have you forgotten this thrilling drilling thread, or that I won a contest for how bad my drilling is was?


Maybe I'm still doing it wrong. I pop the board, I measure the enclosure and drill the holes, then the hardware is mounted in the enclosure and then I place the board onto the pins and needles of the pots and switches...


I'll try MichaelW's methods, they work for him.

 

[Robert]

Sure, but you just verify the circuits work, and then throw all those builds in the same one big box.

Well sure, now, but I've boxed up one or two.

 

[Mentaltossflycoon]

I solder all of my pots and switches outside of the box, and most wiring once it's in the box.

Same. I don't even look at enclosures until it has been rocked.