Any way to mod the Magnetron to output a 100% wet signal?

[ronenk]

Hello, I'm pretty new to all this. Built a magnetron recently and really liked it but was wondering if it's possible to somehow cut the dry signal.

 

[Robert]

Removing R6 will (permanently) cut the dry signal.

 

[ronenk]

Removing R6 will (permanently) cut the dry signal.

Great! thank you, could I do something like route it to a switch?

 

[Robert]

Remove R6. Keep it (or get a new 10K resistor), we'll use it later.

Where the resistor was previous installed, connect one pad to the far left lug of a SPDT toggle switch.

Connect the other pad to the far right lug of the toggle switch.

Install the resistor you removed across the center lug and either one of the outer lugs of the toggle switch.

 

[ronenk]

Thank you so much!