I'm using the Basic Relay Bypass (Latching) with the Copper Clad Fuzz. No substitutions, everything is stock part values. The LED turns on/off with the footswitch, but the sound doesn't change.
The bypass board's IN and OUT pads (from the jacks) maintain continuity, regardless of the LED state. So while I don't actually know if the Copper Clad is functioning correctly, it's a moot point for now because the signal isn't even getting there.
I have not used a relay bypass before so I'm hoping someone can see what I did wrong.
The bypass board's IN and OUT pads (from the jacks) maintain continuity, regardless of the LED state. So while I don't actually know if the Copper Clad is functioning correctly, it's a moot point for now because the signal isn't even getting there.
I have not used a relay bypass before so I'm hoping someone can see what I did wrong.

