Erik S
Well-known member
- Build Rating
- 5.00 star(s)
I know exactly when I put this on my wishlist, because I mentioned it in @HamishR 's thread - HamishR Post
Took a year and a half to make it through the PCB lifecycle and turn into a pedal which is about my usual rate.
As promised, it's a really nice tubey ampy overdrive with lots of subtle control. I like it a lot.
I always forget about the slight interference between boards with this control layout (toggle in top center) and my preferred innie DC jacks. If I planned better, I'd just drill these for a lumberg. In this case I made a custom washer to space the jack out just a little.
I'm still getting used to a newer phone with a different camera focal length than my old one. In order to get a focused full frame pedal shot, I'd need to pull back for the right focus, then crop. Or zoom I guess?
Instead I just keep taking pics where the near-field is slightly blurry, and I don't notice until I post them. Oh well. Maybe I'll remember next time. As they say - Good enough for who it's for.
Took a year and a half to make it through the PCB lifecycle and turn into a pedal which is about my usual rate.
As promised, it's a really nice tubey ampy overdrive with lots of subtle control. I like it a lot.
I always forget about the slight interference between boards with this control layout (toggle in top center) and my preferred innie DC jacks. If I planned better, I'd just drill these for a lumberg. In this case I made a custom washer to space the jack out just a little.
I'm still getting used to a newer phone with a different camera focal length than my old one. In order to get a focused full frame pedal shot, I'd need to pull back for the right focus, then crop. Or zoom I guess?
Instead I just keep taking pics where the near-field is slightly blurry, and I don't notice until I post them. Oh well. Maybe I'll remember next time. As they say - Good enough for who it's for.