Check out this 2x12 or 4x12 multiple ohm jack plate

[RetiredUnit1]

Well this looks totally cool..... I'll be putting this on the 300w 2x12 I have planned !

Jack Plate - Plug and Play, Mono / Stereo | Amplified Parts

The Plug and Play eliminates the confusing switch found on most stereo cabinets. Just pick your impedance and plug in. Label is set at the common 4/16 Ohm Mono and 8 Ohm Stereo. Ready to install with a steel dish, wires, and speaker connectors.

www.amplifiedparts.com

 

[Locrian99]

I put one of these in a 4x12 i had real easy

 

[cwsquared]

I looked at that one but for some reason liked the idea of 2 jack Marshall switched one better. Of course, Mojotone has basically the same thing, with all wires needed for a 4x12, for 2/3 the price. Guess the Marshall labelling costs $20.

Mojotone Stereo/Mono Cabinet 4x12 Wired Jack Plate (Double 1/4")

SpecsDimensions: Outer - 3 1/2" (H) x 4 3/4" (W)Inner - 2 5/16" (H)x 3 9/16" (W)Replacement for the Marshall® stereo/mono 4x12 jack plate (9131200) but withno Marshall® logo. Comes with complete wiring harness for all 4speakers.

www.mojotone.com

 

[Locrian99]

you can get it on amazon, from mojotone and get free shipping

 

[RetiredUnit1]

you can get it on amazon, from mojotone and get free shipping

I was up to $34 on my CE Dist (wholesale amplified parts) order that I've been adding to for the past few weeks and adding the $18.25 for this brought me up over the $50 minimum order. Perfect!

 

[jwin615]

I got one a few weeks back for my carvin legacy cab I recently loaded up. I got as far as pulling the handles last week but still need to make up a few cables to jumper each side. A little bit of a pita going through the (oversized) handles but the front has a stamped mesh grate and some of the holes are getting a little on the lose side.