Hi all just completed my first build and guess what.. I have problems!!
On first plug in bypass signal perfectly fine.. switch on and nothing.. disconnect, have a coffee and look at the forum.. following general advice I had a good look over the board and tidied up a few solder joints.
Attempt #2
Reconnected and.. exactly the same except it starts smoking!!!!!! Power plug out and try to see what the hell happened.. the 10R resistor R2 I think has burned!! Can’t see any other ‘obvious’ damage but better minds may suggest what I should check (Remember I’m a total noob)
Can anyone see anything obviously wrong/stupid that might explain why this happened and what the solution may be?
I should add, on testing continuity on the 3pdt I got a connection between the green(ground) and blue(out) wires when engaged which would suggest to me the effected signal is being sent to ground??
On first plug in bypass signal perfectly fine.. switch on and nothing.. disconnect, have a coffee and look at the forum.. following general advice I had a good look over the board and tidied up a few solder joints.
Attempt #2
Reconnected and.. exactly the same except it starts smoking!!!!!! Power plug out and try to see what the hell happened.. the 10R resistor R2 I think has burned!! Can’t see any other ‘obvious’ damage but better minds may suggest what I should check (Remember I’m a total noob)
Can anyone see anything obviously wrong/stupid that might explain why this happened and what the solution may be?
I should add, on testing continuity on the 3pdt I got a connection between the green(ground) and blue(out) wires when engaged which would suggest to me the effected signal is being sent to ground??