Dali
Well-known member
Since the PCB is not available here and I trust our little community, I will ask. Feel free @PedalPCB to remove the question.
I just bought 3 of these Signal Splitter to build some weird delay and loop setup:
But after the purchase, I realized it requires 4X J201 (so 12!) and since it's a non-musical PCB I was wondering if any replacement would be "good enough" until pre-soldered MMBFJ201 are available here. I'm not a purist with sound. Those are the suggestions I've seen so far.
2N5457 (not available at Tayda)
MPF102 (not available at Tayda)
2n5458
Anyone want to express themselves?
I just bought 3 of these Signal Splitter to build some weird delay and loop setup:
Spluffer - Buffered signal splitter - Board Mounted
Neat little circuit to split your guitar signal without any signal loss, based on the AMZ Splitter Buffer. This version keeps everything neatly board mounted with no wiring, unless you opt for the wired DC socket. Designed for a mini 1590A (36 x 90mm) enclosure with DC power only in horizontal...
shop.pedalparts.co.uk
But after the purchase, I realized it requires 4X J201 (so 12!) and since it's a non-musical PCB I was wondering if any replacement would be "good enough" until pre-soldered MMBFJ201 are available here. I'm not a purist with sound. Those are the suggestions I've seen so far.
2N5457 (not available at Tayda)
MPF102 (not available at Tayda)
2n5458
Anyone want to express themselves?