Keeley Caverns/Other Delay and Reverb in one

[megatrav]

Has anyone traced a Keeley Caverns?
If not, then maybe something similar that is delay and reverb in one pedal?

 

[Danbieranowski]

The FV-1 dev board would let you load a reverb delay into the eeprom. I am planning to build one for this purpose.

 

[manfesto]

The Delay half of the Caverns is the Magnetic Echo, so PedalPCB Magnetron.

The ThreeVerb's algorithms are comparable to the Caverns's algorithms.

You could fit a Magnetron and a ThreeVerb in a 1590XX side-by-side, a little bigger than a Caverns though

 

[megatrav]

Thanks for the responses! I am still really new at building and in the "paint- by numbers" phase. When you combine 2 effects in one, do you have to do something different with the power?

I don't mind if it is larger than the Caverns. I suppose the real solution would be have a single board printed to include both so it wouldn't take up as much space?

Anyway, thanks!

 

[Nostradoomus]

Nope you just tie them both to the supply. These boards are handy for this purpose

DC Jack Breakout Board - PedalPCB.com

Power Breakout Board

www.pedalpcb.com

 

[megatrav]

Very cool! Thanks for the help

 

[Danbieranowski]

This will be a fun project!

 

[manfesto]

The wiki has a wiring diagram for 2-in-1 pedals that'll work for those two boards. If you use the 3PDT breakout boards it's even easier, you just run a wire from the right-most pad on the first switch to the left-most pad on the second switch.

2-in-1 Pedal Wiring - PedalPCB Wiki

wiki.pedalpcb.com

 

[allsmoke]

Sorry to bump this old thread, but it kind of answers the question I had (how to build a caverns type pedal).
The only other question I have is this. How hard would it be to add a blend knob to this, like the caverns has.

If it possible to add on this dual pedal setup?

Thanks all

 

[Synchrony Pedalworks]

Sorry to bump this old thread, but it kind of answers the question I had (how to build a caverns type pedal).
The only other question I have is this. How hard would it be to add a blend knob to this, like the caverns has.

If it possible to add on this dual pedal setup?

Thanks all

See if this would help blend the circuits.

Buff N Blend v2 - Add a Buffer and Blend Control - GuitarPCB

Add a Blend Control t o any circuit with our Buff N Blend just like the Pro's.

guitarpcb.com

 

[manfesto]

Sorry to bump this old thread, but it kind of answers the question I had (how to build a caverns type pedal).
The only other question I have is this. How hard would it be to add a blend knob to this, like the caverns has.

If it possible to add on this dual pedal setup?

Thanks all

The “Blend” on the Caverns is Reverb side is the same as the “Mix” knob on the ThreeVerb, and same with the “Blend” knob on the Delay side.