ninjagrips
New member
So I recently bought and built both a Diplomat and a King Nothing.
The Diplomat works great, but the King Nothing does not. I get a signal going through it when it’s not active, but if I stomp the switch, the sound cuts out and the LED doesn’t turn on.
I can’t figure out what I’ve done wrong. I’m attaching a pic of the build.
I’ve tried two different tubes so far.
Can anyone help me diagnose what’s going on here? I would really appreciate it!
Edit: I may have screwed up the switch daughter board. I was trying to make sure none of the pads had solder connecting them and I stupidly scratched some of the mask off. I also swapped out the switch, thinking maybe there was something wrong with the first one.
The Diplomat works great, but the King Nothing does not. I get a signal going through it when it’s not active, but if I stomp the switch, the sound cuts out and the LED doesn’t turn on.
I can’t figure out what I’ve done wrong. I’m attaching a pic of the build.
I’ve tried two different tubes so far.
Can anyone help me diagnose what’s going on here? I would really appreciate it!
![IMG_5490.jpeg IMG_5490.jpeg](https://forum.pedalpcb.com/data/attachments/67/67978-5f7ac483c3e51dc34466489f91f99637.jpg)
Edit: I may have screwed up the switch daughter board. I was trying to make sure none of the pads had solder connecting them and I stupidly scratched some of the mask off. I also swapped out the switch, thinking maybe there was something wrong with the first one.
![IMG_5503.jpeg IMG_5503.jpeg](https://forum.pedalpcb.com/data/attachments/67/67979-dac5ecc6bc2aa84ab69981e08b4f36c2.jpg)
Last edited: