Kliché Overdrive

[jojofogarty01]

Just finished up the kliché build. This one sounds killer! I used a Gorva s90 enclosure that I polished to a somewhat mirror finish. The knobs are the Klon clones from lovemyswiitches.com. I used the new kliché 3pdt breakout board too. Finally, I socketed the germanium diodes just in case I wanted to change them out down the line.

 

[PapaBear]

Nice

 

[Bucksears]

 

[Dan0h]

SWEET!

 

[BuddytheReow]

How did you get that shine? Sandpaper up to a super fine grit then car polish?

 

[jojofogarty01]

How did you get that shine? Sandpaper up to a super fine grit then car polish?

I sanded up to wet 1500 and then I used a polishing wheel that I put in my drill press chuck. I don't have a buffer/polisher on my bench so I had to make do with what I had. I used this one here from harbor freight: https://www.harborfreight.com/5-piece-buffing-and-polishing-kit-67259.html

 

[Chuck D. Bones]

Simply beautiful! Nice job on the insides and the outside.

 

[jwaugh89]

Did you buy the kliche PCB board and the 3pdt breakout board separately or did it come with the kliche PCB that you ordered? I ordered the kliche PCB and it came with with the 3dpdt board and PCB all "connected" together by an outer piece of plastic. This is a noob question but should I snap these pieces out of the outer piece of plastic or keep them there?

 

[PapaBear]

Did you buy the kliche PCB board and the 3pdt breakout board separately or did it come with the kliche PCB that you ordered? I ordered the kliche PCB and it came with with the 3dpdt board and PCB all "connected" together by an outer piece of plastic. This is a noob question but should I snap these pieces out of the outer piece of plastic or keep them there?

can you post a picture?

 

[Robert]

This is a noob question but should I snap these pieces out of the outer piece of plastic or keep them there?

You should snap them apart.

 

[BeeSharp]

That polish! Just don't play any outdoor sunny gigs!