SOLVED LED Not working with breakout board on Cleric Fuzz

[overdriver999]

hey just finished up my newest build and encountered a minor issue...works fine but no LED working...i've tried digging around here a bit but wanted to ask the pros before i went desoldering anything....this is my first build using the trimmer LED boards and there's not any documents that i've found that say what trimmer to use or any special instructions....the CLR on the main board and the daughter board are 4.3k and trimpot is 10k i believe...any ideas ? many thanks in advance.

 

[Robert]

You need to install a jumper wire across the A/K LED pads of the main PCB since you're using the breakout board with LED.

 

[overdriver999]

You need to install a jumper wire across the A/K LED pads of the main PCB since you're using the breakout board with LED.

ok i'll give it a try tonight...i saw some talk of that here and there looking for the answer but wanted to be sure before i did it...thanks so much!

 

[overdriver999]

You need to install a jumper wire across the A/K LED pads of the main PCB since you're using the breakout board with LED.

thank you again my friend...that did fix my issue...i really appreciate the help