"switch it up" he says, but he doesn't say which switch. Or did he mean one of the dip-switches, or ... all switches all up?
Yokin acide, it's always been my intention to do make my Muffin Factory a Kustom jobby.
This?
Or
Versions Part # (Aion),Part # (Kit Rae),V1 Perf,Foxey Lady,Triangle Standard,Triangle '72,Ram's Head "47",Ram's Head '73,Ram's Head '73 Gilmour,Violet Ram's Head,Violet Ram's Head (#2),Ram's Head White Can,Ram's Head '75 Schematic,Ram's Head Box Cap,V3,V3 Tone Bypass,Civil War / Red Army,NYC Re...
docs.google.com
Nope, as stated, the one I'm thinking of was for the Mudbunny, MadBeanPedals.
I've added your Aion one to my Muff n Around folder. Merci Beaucoup!
Edit found the MBP ref-des PDF I made, but the URL is defunct so I made a JPG which had crappy resolution so...
A screen-grab of the PDF and Juansolo's your uncle:
Here's the Key to the blue-highlighted bits:
[1]
John Arnold:
This is inline with R6. The line is then pulled from between. As the Mudbunny doesn't support this, use a 10k as R22 instead
[2]
John Arnold:
Leave leads long on R23 and put 10uF electrolytic cap and 2k resistor in series across them. In that order, towards ground.
[3]
John Arnold:
From tone 2 pad to pot
[4]
John Arnold:
0R can be a jumper
[5]
John Arnold:
Switched in parallel with R2
[6]
John Arnold:
Lift one end of R18 and run a wire from the resistor to pin 2. Connect other pad to pin 1.
[7]
John Arnold:
Pins 3&2 linked
[8]
John Arnold:
Pin 3&2 linked. B50K pot will be ok.
[9]
John Arnold:
Pot used in place of R19 wired to pins 1&2. Pin 3 is not connected
[10]
John Arnold:
Pin 3&2 linked
[11]
John Arnold:
Connect in parallel with C10. The tone side goes though a 33nF cap to pin 3 of the pot. Pins 1&2 connect to the other side.
[12]
John Arnold:
negative towards R2
[13]
John Arnold:
negative towards R2
[14]
John Arnold:
Ceramic. C15 when blanked should be omitted, not jumpered
[15]
John Arnold:
P19 uses 50KB tone pot
[16]
John Arnold:
DPDT on/off/on wired in parallel with a 2.2nF on one side and a 6.8nF on the other
[17]
John Arnold:
With additional 6.8nF wired in parallel on a switch
[18]
John Arnold:
Between tone 2 and ground
[19]
John Arnold:
Between sustain pins 3 and 2
http://juansolo.co.uk/stompage/Muffs.htm Page 2 of 3
27/5/16 3:23 am
[20]
John Arnold:
Between volume pins 3 and 1
[21]
John Arnold:
Switched with D3&4
[22]
John Arnold:
Covered by the Schottky in R24