On-on-on switch mount?

[ChezWorld]

Working on a Byrdhouse Compressor, which has a trim pot on board plus a 3-way o-o-o switch. Typically the pots and LEDs are soldered to the “underside” of the PCB, and the trim pot is topside. I’m assuming the switch also needs to be put on the underside also, right?

 

[peccary]

I deleted my reply after re-reading because I wasn't sure that I was answering what you needed, but now re-reading (again) I think it was. Sorry about that.

If you're talking about the toggle switch, yeah, that'll go on the side with the pots. I would recommend not soldering your pots or switch until you have your enclosure drilled and can use the enclosure as a soldering jig for your pots and switches. Check out this build guide for photos: https://forum.pedalpcb.com/threads/basic-workflow-tips-for-building-a-pedalpcb.1165/

 

[ChezWorld]

Thanks, yes that’s what I needed. Was getting confused for some reason and was going to put the switch on the other side!

thanks for the link too.

 

[Coda]

Was getting confused for some reason and was going to put the switch on the other side!

I can almost guarantee that everyone here has done that at least once...