maxamendel
Member
- Build Rating
This took five hours.
Thanks to ANOMALOUS on youtube for the walkthrough.
this is my first point to point. its a very simple clone of the EHX LPB1. I used a 2n5088 transistor and a 390R gain resistor instead of 330R.
the hardest part of this build was the small enclosure.
I learned my lesson about why builders do the I/O jacks opposite from what I did; I wish I had had more room on my ground bus than the power bus.
I used 18awg bell wire for the power rails and 20awg for the signal wire.
the transistor is installed backwards but surprisingly it works fine.
I would do this again. it was a lot of fun and very rewarding. Next lpb, im gonna experiment with transistors and maybe try a mpsa14 transistor.
Thanks to ANOMALOUS on youtube for the walkthrough.
this is my first point to point. its a very simple clone of the EHX LPB1. I used a 2n5088 transistor and a 390R gain resistor instead of 330R.
the hardest part of this build was the small enclosure.
I learned my lesson about why builders do the I/O jacks opposite from what I did; I wish I had had more room on my ground bus than the power bus.
I used 18awg bell wire for the power rails and 20awg for the signal wire.
the transistor is installed backwards but surprisingly it works fine.
I would do this again. it was a lot of fun and very rewarding. Next lpb, im gonna experiment with transistors and maybe try a mpsa14 transistor.
Attachments
Last edited:
