Paragon Wiring

[untamedfrontier]

In the midst of a Paragon build right now and I'm going to use some of the lovely Demont 3pdt's, but they don't fit with the included board (the ol round peg square hole conundrum). Any suggestions for wiring without the board?

 

[Barry]

Take an ohm meter to the switch board and check continuity from the switch hole to holes that go to the board, or if your lucky Mr Pedal Pcb will whip up a diagram

 

[untamedfrontier]

Thanks Barry, here's what I came up with! Hopefully my art skills don't go unnoticed ?
EDIT: Had my diagram wrong. This is accurate now

 

[Dondutch]

Thanks Barry, here's what I came up with! Hopefully my art skills don't go unnoticed ?
EDIT: Had my diagram wrong. This is accurate now

I’m in the same boat…is this wiring correct?

 

[PunchySunshine]

In the midst of a Paragon build right now and I'm going to use some of the lovely Demont 3pdt's, but they don't fit with the included board (the ol round peg square hole conundrum). Any suggestions for wiring without the board?

SOLVED - Paragon footswitch brute trace lifting

I was trying to replace a footswitch that had gotten sticky in my Paragon. While my soldering skills have improved over the past year I was very sad to see my DEsoldering skills have gotten worse! Six out of nine traces pulled off the breakout board! MOTHAF!#$% So now I guess I just have to...

forum.pedalpcb.com