I put two small circuits on a perf board. First is pre amp, then a cab sim. The diagrams attached are from effect layouts blog. Neither worked at first then I got the pre amp to work. After, I got the cab sim to work but then the pre amp didn’t work any longer. I ran a prob through it and it stopped working at the G point on the trans but not on the other points of the trans. I think I killed it when the second circuit was on. I want to switch out the trans (j201) but don’t want to just kill that one too.
My question is: do I need anything to separate the power between the circuits?
My question is: do I need anything to separate the power between the circuits?