Tleslie474
New member
I’ll start this by saying I am a dummy, not an electrician, and by no means a circuit board guru. I am an above average DIY’er with considerable soldering skils. Long time listener, first time caller….
I want to know if it is even possible to (and obviously how to) replace what I believe is a DPDT (6 pin) foot switch in an MXR Dyna Comp with a 3PDT with LED foot switch? I am just starting to dabble in repairing my own pedals as this is the first one that has failed and I ended up with a few of these switches that I would like to use. Any assistance would be appreciated. Obviously, the new switch isn’t going to be a direct replacement to the board, but is there a way to jumper what needs to go where?
I want to know if it is even possible to (and obviously how to) replace what I believe is a DPDT (6 pin) foot switch in an MXR Dyna Comp with a 3PDT with LED foot switch? I am just starting to dabble in repairing my own pedals as this is the first one that has failed and I ended up with a few of these switches that I would like to use. Any assistance would be appreciated. Obviously, the new switch isn’t going to be a direct replacement to the board, but is there a way to jumper what needs to go where?