Sanguine low output

[lifer2624]

Hey everyone,

I'm running into an issue with my Sanguine build. This is my 14th build, and it's the first time I've had a problem like this. The circuit works, but when the pedal is engaged, the output is attenuated. So the signal is still getting through but the clean signal noticeably louder.

The only obvious issue I've encountered so far is that two potentiometers (mid and treble) broke while buliding, so I desoldered them and replaced them. While removing the mid pot, I suspect the solder pad for leg 1 may have come off, but when I checked for continuity, everything seemed OK.

I can tell that the volume and gain pots, as well as the aggression switch, are functioning properly. I'm not entirely sure about the mid pot, and I’m having a hard time determining whether the treble and bass controls are working as they should.

To troubleshoot, I also swapped out all three op-amp ICs, but that didn't change anything.

Has anyone encountered a similar issue or have any ideas on what to check next?

Thanks!

 

[Robert]

Check for continuity between these points.

(For example, Gain Pot Lug 1 to the Right end of R16, looking at the component side of the PCB)

Gain (1): R16 (R)
Gain (2): C12 (+)

Volume (1): GND
Volume (2): OUT pad
Volume (3): R33 (R)

Treble (1): C20 (R)
Treble (2): R24 (L)
Treble (3): C19 (L)

Mid (1): C25 (R)
Mid (2): R30 (R)
Mid (3): R28 (R)

Bass (1): R22 (R)
Bass (2): R23 (R)
Bass (3): R21 (R)

 

[lifer2624]

Thanks for the quick reply!

All those points check out, but after further testing of the pots, I found that the gain pot seems to be faulty. Measuring the resistance from end to end changes depending on the wiper position.

 

[Robert]

Are you making that measurement with the pot removed, or still in the circuit?

That's normal if the pot is still in circuit.


If all of the continuity measurements checked out then the traces to the pots are fine. Post some pics of the component side of your PCB.

 

[lifer2624]