Ok, so not a pedal troubleshooting per se, but this came up after putting my new Old Chap flanger (which is an amazing flanger btw) onto my board. The pedal works just fine and is dead silent when in bypass or by itself (also tried it with just my Ge sandspur and was fine), but if I drop it into my normal chain, I get a lot of digital background noise as heard here:
Doesn’t matter where in the chain I put it. Is this just a matter of needing some shielded wire on the inside?
Any other mitigation steps I can take to keep this bad boy on my board?
Edit: signal chain might help Timmy->klon->Octarock->parenthesis->reverse—>swah->hydra->old chap
Any other mitigation steps I can take to keep this bad boy on my board?
Edit: signal chain might help Timmy->klon->Octarock->parenthesis->reverse—>swah->hydra->old chap