Sproing Deluxe

[KindCanuck]

Had a few fender knobs hanging around, good fit for this pedal. The red LEDs reminiscent of the black panel fender lamps.



Inside is pretty simple, I gotta start using the 3PDT breakout boards on all my builds.



I like my makeshift header connection here, much tidier than short wires.

Thought I’d post these while I’m waiting for the remaining pots to show up. Thanks for reading, let me know what you think!

 

[KindCanuck]

It’s complete! Sounds great and will replace the Flint on my board while looking fresh as fuck!

I love the texture I got on the enclosure, really reminds me of Tolex.

 

[jcrews]

This looks great. I ordered it and I'm nearly done myself. What LDR did you use? There are several available with diff resistance etc. Can't figure out what to order..... Great looking build btw.

 

[KindCanuck]

This looks great. I ordered it and I'm nearly done myself. What LDR did you use? There are several available with diff resistance etc. Can't figure out what to order..... Great looking build btw.

I bought a multi pack from Amazon that had gl5516 in it since I needed some for a compressor build as well.

Yosawa 150-Pcs Photo Light... https://www.amazon.ca/dp/B07JDN4QR9?ref=ppx_pop_mob_ap_share

 

[Dan0h]

Dude that’s awesome.

 

[KindCanuck]

Finally figured out the water slide paper I have. It said it was no spray, but I definitely needed to spray a clear coat on, it wasn’t sticking to the PCB material the faceplate is made of.