thesmokingman
Paid Hater
I really like the way it turned out (tone-wise). I really don't like that the bottom plate (with battery door) no longer fits ... now I'm shopping bottom plates
Tearjerker
- Thread starter thesmokingman
- Start date
Chuck D. Bones
Circuit Wizard
Nice! Those don't look like MPSA18s.
2 questions:
Which inductor did you use?
What's on that little daughter board, a buffer?
2 questions:
Which inductor did you use?
What's on that little daughter board, a buffer?
thesmokingman
Paid Hater
BC109 transistors
Whipple inductor, Area 51 pot
Yes, that's the pedalpcb jfet buffer on the output for more fuzz friendly wah. I used the super-thick leads from the protection diode to board-mount and power that off the LED pads (note the jumpered LED resistor). In order to not get capacitor pop, just jumper the LED switch pads on the 3PDT.
Whipple inductor, Area 51 pot
Yes, that's the pedalpcb jfet buffer on the output for more fuzz friendly wah. I used the super-thick leads from the protection diode to board-mount and power that off the LED pads (note the jumpered LED resistor). In order to not get capacitor pop, just jumper the LED switch pads on the 3PDT.
thesmokingman
Paid Hater
yeah the batter door does not clear the bottom of the PCB, specifically the DIP switch and MID control. I can probably add a pic of the bottom plate sans battery door if you need an idea of "by how much"
Chuck D. Bones
Circuit Wizard
Two words:
"Duct Tape"
"Duct Tape"
