ANGRY_SWEDE
Active member
My usual "go-to" method for testing a circuit is to simply connect [+] [-] IN and OUT of each channel. Is this not possible to test each channel of the Thermionic Deluxe individually w/o everything being wired together? My breakout box was connected to IN and OUT pads in place of 3PDT, but I was only able to get signal from the set of right side pads [top row of pots], not the LEFT side of pads [bottom row of pots]. I reflowed everything on the bottom half of the pcb to no avail.
Thank you for any help, in advance!
Thank you for any help, in advance!