What’s on *YOUR* workbench?

DGWVI said:
Didn't get home nearly as early as I thought I would, so no demos, but i did manage to slip this guy in before bedtime -
View attachment 64342

I think it's easily the most polite envelope filter I've ever played- it doesn't do anything weird or wacky, and dialing it in is super intuitive, even so far as not having to move the pots between the up and down modes
Click to expand...


1000019413.jpg

To be fair, I haven't really mussed too much with this latest batch of builds until this one.

I'll have a demo report tomorrow, but until then, you should definitely snag one of these while Lectric has them in stock- it's fucking rad
 
DGWVI said:
View attachment 64450

To be fair, I haven't really mussed too much with this latest batch of builds until this one.

I'll have a demo report tomorrow, but until then, you should definitely snag one of these while Lectric has them in stock- it's fucking rad
Click to expand...
I've been eyeing this 'n, trying to figure out how small of an enclosure with top-jacks — 1590B3 was maybe a contender, but I guess 1950BB vertical is the way to go.
Looking forward to the build report and what that extra footswitch and toggles are for!
 
Feral Feline said:
I've been eyeing this 'n, trying to figure out how small of an enclosure with top-jacks — 1590B3 was maybe a contender, but I guess 1950BB vertical is the way to go.
Looking forward to the build report and what that extra footswitch and toggles are for!
Click to expand...

I definitely recommend this one. Boss really outdid themselves with the peak detector in it, particularly the biasing of the Up sweep.

It could easily fit in a 125b with top jacks if you rearrange the controls a bit, and move the boards toward the footswitch. Just gotta be mindful of that little overhangy bit shorting out on the FS lugs
 
That’s what I was thinking, lower the board, but then the rotary is too close to the footswitch?

I’ll get a better idea when I’ve got boards on hand, I can’t do that 3D-modelling all the whippersnappers conjure on compooters.
 
Feral Feline said:
That’s what I was thinking, lower the board, but then the rotary is too close to the footswitch?

I’ll get a better idea when I’ve got boards on hand, I can’t do that 3D-modelling all the whippersnappers conjure on compooters.
Click to expand...
When I was originally going to box it up as I described, I was going to leave the Sens and Q pots soldered to the board, and solder the rotary and cutoff with flying leads above the Sens and Q
 
temol said:
Transparent copper has been on my shopping list for a long time.

I like the darkened edges. But with transparent powders this is usually an unintended effect, at least in my case. No matter how hard I try, the edges usually get a little extra powder.
Click to expand...
Thats exactly whats happening here. I figured id rather get a little more on the edges than to not have any powder on them at all. I find that this powder is very hard to get even without to much buildup in one area. I think its the clear nature of it.
jwin615 said:
That's just begging for a big ole bakelite knob.
Click to expand...
Or even those Ox blood Davies knobs :unsure:

Erik S said:
Integrated tabs!! Gettin fancy!
Click to expand...
I think the tabs make it look super unique! In all honesty though not having to make those brackets is the biggest headache reliever :ROFLMAO:
 
You must log in or register to reply here.
Back
Top